Study Guide
Sanitizer Concentrations in Canadian Kitchens: Chlorine, Quats and Test Strips
A sanitizer that is too weak does not do its job, and one that is too strong can leave a chemical residue on food. That is why food handler courses spend time on concentrations, contact time and test strips.
By Mayu Sato Published 7 min read
Cleaning is not sanitizing
Cleaning removes visible soil, grease and food residue with detergent and water. Sanitizing reduces the number of microorganisms on a clean surface to a safe level. Sanitizer works poorly on a dirty surface because food residue shields bacteria and uses up the chemical, so the order always matters.
Interior Health's poster for food contact surfaces shows the sequence used across Canada:
- Wash with hot, soapy water.
- Rinse with clean water.
- Sanitize with a sanitizing solution at the right concentration.
- Let the surface air dry. Do not towel dry, which can re-contaminate it.
Typical concentrations
Interior Health (BC) gives these ranges for food contact surfaces:
| Sanitizer | Concentration | How to mix |
|---|---|---|
| Chlorine (unscented 5% household bleach) | 100–200 ppm | About 5 mL of bleach per litre of water |
| Quaternary ammonium ("quats") | 200–400 ppm | Follow the manufacturer's instructions |
Other health units and other provinces publish similar but not identical figures, and the required concentration for dish sanitizing in a sink or machine can differ from the figure for wiping surfaces. Always use the product's label directions and the figures your inspector gives you; the table above is one health unit's published example, not a national standard.
Contact time and changing solutions
Sanitizer needs time on the surface to work. For the spray-bottle method, Interior Health says to let the surface air dry after spraying for 2 minutes before wiping. For the bucket-and-cloth method, keep the wiping cloth stored in the sanitizer bucket and change the solution every 2 hours, or sooner if it becomes dirty; spray bottles should also be made fresh every 2 hours or as needed. Bleach solutions in particular lose strength over time and when food soil gets into them.
Continuously used food contact surfaces should be cleaned and sanitized before use, after any contamination, and at least every 4 hours, according to the same Interior Health guidance.
Why you test with strips
You cannot see or reliably smell the concentration of a sanitizer. Test strips (chlorine strips for bleach, quat strips for quaternary ammonium) change colour to show the concentration. Interior Health's guidance is to confirm sanitizer concentration with test strips and to label all containers. A good habit is to test every new batch and record the result in your sanitation log.
- Too weak: remake the solution, adding more concentrate.
- Too strong: dilute it. Overly strong sanitizer can leave a residue and is harder on skin and equipment.
- Wrong strip: chlorine strips do not measure quats, and the reverse is true too.
Safety with chemicals
Never mix bleach with other cleaners, especially products containing ammonia or acids, because dangerous gases can form. Store chemicals away from food, in labelled containers, and keep the safety data sheets (SDS) where staff can find them. BC's Food Premises Regulation is a good example of how this is written into law: section 24 requires every food service establishment to have written sanitation procedures that identify the cleaning and sanitizing agents used, including their concentrations and uses, and section 27 requires chemicals to be stored in a room or cabinet separate from food, in clearly labelled non-food containers.
Exam tips
- If a question asks what comes first, the answer is cleaning, then rinsing, then sanitizing.
- If a question asks how to check a sanitizer, the answer is a test strip, not smell or colour.
- If a question asks how to dry sanitized equipment, the answer is air drying.
Practise with our cleaning and sanitizing questions.
Sources and further reading (last reviewed November 2026)
Temperatures, training rules and fees are set by Health Canada, the CFIA, provincial governments and local public health units, and they change. Where this page states a regulatory fact, it is based on the official pages below. If anything here disagrees with them, the official source wins. You can read how we review and correct content.